halaman

Pencarian

Jumat, 25 Oktober 2019

Original TLE 6288 TLE6288R 6288R TLE6288 Smart 6 Channel Peak Hold Switch PDSO36

Original TLE 6288 TLE6288R 6288R TLE6288 Smart 6 Channel Peak Hold Switch PDSO36



Infineon TLE6288R - ECU Injection Module Repair Component (Drive)
Manufacturer: Infineon Technologies Corporation
Part         : TLE6288R, TLE 6288 R.
Case : PDSO36
Replacement : Infineon TLE6288R, Infineon TLE 6288 R.
Can Be Found : Bosch ECU MEG17.9.12, Bosch MG7.9.8, etc.

Application • Peak & Hold Loads (valves, coils) • Solenoids, Relays and Resistive Loads • Fast protected Highside Switching (PWM up to > 10 kHz)



Minggu, 20 Oktober 2019

Modul BMS Baterai 18650 4S 40A Li-Ion Lithium Battery Charger Pcb Bms Protection Board 16.8V

Modul BMS Baterai 18650  4S 40A Li-Ion Lithium Battery Charger Pcb Bms Protection Board 16.8V

Cope: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650,26650 polymer lithium battery)
Charging voltage: 16.8 V-18.1 V
Continuous discharge current (upper limit): 40 A (if the cooling environment is not good, reduce the use of charging current)
colour: green




Features:
4S 40A Li-ion Lithium Battery 18650 Charger PCB BMS Protection Board with Balance For Drill Motor 14.8V 16.8V Lipo Cell Module
4 string 16.8V 40A lithium battery protection board (comes with recovery function-AUTO Recovery)
Scope: Nominal voltage of 3.6V, 3.7V lithium battery (including 18650,26650, polymer lithium battery)
Product Size: 46 * 60 * 3.4mm (balanced version)
Product weight: 10.3g (balanced version)
Charging voltage: 16.8V - 18.1V
Continuous discharge current (upper limit): 40A (if the cooling environment is not good, please reduce the load current use)
Continuous charge current (upper limit): 20A
Equalization version: suitable for starting current below 80A, power 135W below the drill.
Note:
1: The successful start of the drill requires three 15C-20C power battery, or six 10C-15C power battery (ordinary 18650 can not start the drill!!).
2: strictly according to map wiring 0V, 4.2V, 8.4V, 12.6V, 16.8V, do not deliberately short circuit.
3: When the load of the brush motor is used, try to connect a non-polar capacitor (withstand voltage above 25V, capacity 10uF-100uF) to the motor's positive and negative terminals to prevent the reverse spike from the motor. Break the MOS tube.
4: 4 groups of batteries in series, please ensure that the voltage of each group of batteries, if not the same, please fill each battery separately and then use in series. The The Discharge test, the voltage drop faster battery that group is poor battery.

 Package included :
1 4S 40A Li-ion Lithium Battery 18650 Charger PCB BMS Protection Board with balance

 
Design by http://agusyulianto2.blogspot.com/ | Bloggerized by Agus Y